![]() |
![]() |
![]() |
|
|
XT660Z Mods Share views on all the mods you have done and those you intend to do |
![]() |
|
Thread Tools | Display Modes |
#
1
|
|||
|
|||
o2 optimizer
Hi, Just been starring at my bike for the last 1/2 hour wondering what is the easiest way to refit the o2 sensor!
About 2 years ago I installed a PC V, DNA stage 1 and 2, Akrapovic single can and an O2 eliminator. I think I have read that the O2 eliminators do not work therefore I bought a dynojet O2 optimizer from the nec bike show last week. When I had a custom map made the guy removed the O2 sensor as it was now replaced by the O2 eliminator. My question is that now I want to use the O2 optimizer and re install the O2 sensor what is the easiest way to put the sensor back in the pipe? Remove pipe? or can I get to it by removing the bash plate (i have an adv spec bash plate). Many thanks |
#
2
|
|||
|
|||
You can get it in/out with the pipe in place, but it is unlikely to be easy due to the probability of the blanking plug having seized in the hole. You can't use a lot of brute force because the pipe isn't that securely attached to the bike and you're most likely to break something, plus there's not a lot of room for wielding a spanner! Best to remove the header and then you can clamp it in a vice and apply heat if necessary and you'll have plenty of room for spannering.
|
#
3
|
|||
|
|||
Might pay to give it a good soak for while with WD40 or something first before too.
|
Sponsored Links |
#
4
|
|||
|
|||
Thanks guys for you quick replies. Managed to get the down pipe off and fit the O2 optimiser. Will take it for a spin at some point to see what's new?
|
#
5
|
|||
|
|||
PCV autotune
Can any1 tell me if the autotune writes / corrects the mapping when the switch is open or closed ?
|
![]() |
Thread Tools | |
Display Modes | |
|
|