Hi guys,

I have been looking for a set of wider pegs for a while now, i found the quality ones way to expensive and i do not dare to rely on the chineese ones. I had a good look at the stock ones after i removed the rubber, i decided then to go forward with a good old diy.

Used a piece of flat iron, drilled 6mm holes 1.2cm apart close to the edge of the flat iron , used a grinder to cut a V shape on the top part of the holes to get the sawtooth like pattern, ones i was happy with the shape i cut the piece in to two equally sized pieces, bended them in to a oversize u-shape compared to the original footpeg. Got my tigwelder out and prepared the pieces for the welds, i used some rod and some pieces of a larger flat iron to fill up the gap between the old and and new peg. All i need now is to get my grinder out and cut a little bit here and there to finish them off, ready for paint..

Sure they will be fine and cost me nothing apart from a cutting disc and some current + my time.

See the photos



Kind regards

Ulrich

Attached Images

	IMG_1349.jpg (171.6 KB, 60 views)
	IMG_1350.jpg (175.6 KB, 48 views)
	IMG_1351.jpg (176.1 KB, 43 views)

Looks good.

__________________
2011 xt660z.
Yoshimura cans ,kev mod,Dna 2, Stahlkoffer panniers,Hepco Becker box,Givi crash bars,Mita e07 tyres.

Neat job....! Steve

Like that ....really nice job

Looking good. You've inspired me to dismantle some old bear-trap pedals I have lying about from my mountain bike stock and see what might come of it.

__________________
I have a lot of growing up to do. I realized that the other day inside my fort.

i LOVE DIY stuff!!!

Nice job. Hmmm, I think I see another night shift project coming up