|
|
#
1
|
|||
|
|||
DIY Snorkel/ Air Intake mod
Hey guys just fitted up my new o2 and fuel controller (thanks Kev!
So ive modded my intake, I didn't want to butcher the snorkel or buy the DNA intake so I made this up using some left over rubber that I line my work bench's with and a $1.05 pvc floor flange from bunnings. Also note ive kept the Aus 2 piece foam unifilter because it does a better job stopping fine dust than the k and n or Dna filter does. First cut the rubber to a circle 115mm round to fit the airbox snug as well as the top of the unifilter. And cut a hole in the center so the flange can fit it. You could mount this downward or upward. I chose upward so I could possibly adapt a throw-away filter sock onto it if needed. Also applied some filter oil to the rubber.
And fit original snorkel base over the top and tighten screws to form a perfect seal.
All finished, pretty simple, but thought I would share
Last edited by tougefc; 21-09-16 at 05:52. |
#
2
|
|||
|
|||
That looks good. The DNA filter lid is pretty expensive by comparison and your DIY job should work the same.
Does it seal tight against the filter top rim?
__________________
2014 XT660Z - Barrett pipe, DNA stage1.5, Barkbuster hand guards and handlebars, Pivot pegs, Teknik suspension, Guard-it engine protector combo, B&B rear rack, Trax topbox. |
#
3
|
|||
|
|||
Thanks yes it seals super tight
|
Thread Tools | |
Display Modes | |
|
|