|
|
|
|
|
|
|||||||
| General Help Section Members help each other here with tips and tricks about mods / maintenance and servicing based on their own experiences |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#
1
 24-06-16, 18:10
|
|||
|
|||
|
New CNC Levers, Brake Side Spring??
Hiya guys, recently bought some CNC levers for my XTX, clutch lever fits fine, but I noticed that on the brake side, on the stock lever there was a hole for a spring to fit, where as on the CNC ones, there's no place for it to sit, so it's sitting in an awkward position and not working 100% as intended.
https://www.ebay.co.uk/itm/191901703493 These are the ones I've bought. Not sure where to go now, as the spring is pushing slightly on the rubber where the lever pushes on. Any advice? Thanks in advance, Jake |
|
| Thread Tools | |
| Display Modes | |
|
|
|
|
Hybrid Mode
