Was out and drove a round today when the bike suddenly died and the engine light came on. Looked a bit for loose wires or leaks but could not see anything. What could have happened? Waited a few minutes then started the bike again and the engine light was not showing. Then it died again after a few seconds. Waited again and started then I could drive the 10 miles home without the enginelight on. Have just installed kevs fuel mod and O2 controller but it'll surely not have affected anything? It ran great before it stalled.
Anyone?


Skickat fr�n min iPhone med Tapatalk

Now this is showing.
ImageUploadedByTapatalk1457795901.297323.jpg


Skickat fr�n min iPhone med Tapatalk

??? http://www.yam-xt.com/forum/viewtopic.php?t=821

__________________
XTX 09

Maybe its something wrong with the o2 controller cause when I dissconcted it the bike worked again and when I connected it again the same problem occurred?


Skickat fr�n min iPhone med Tapatalk

Now I know what the problem is. Its the tilt sensor. I went into diag mode and it seems to be ok now. But whats the chance that this would happen again. Should the sensor be replaced or something?


Skickat fr�n min iPhone med Tapatalk

If you know the bike hasn't gone over and the tilt sensor has tripped then it may well be faulty. I'd see how you go, and if it happens again, look into getting a replacement.

__________________

As mentioned in the emails directly to me, check the tilt sensor connector for corrosion, if it is free of corrosion I would personally replace the tilt sensor as we have seen a few go over the years.

Looking in the dash the voltage in zone 08 must be 0.6Volts when the tilt sensor is working correctly.

__________________
Click here to join the XT Supporter's scheme

Mods that I have done to my XTX's

My 04 XTX
Stage 1 & 2 DNA filters / Kev fuel mod / snorkel mod / Drilled air box mod / Engine breather mod / Fork Spacer mod / 15w fork oil /
[
My 07 XTX
Raptor 700 cylinder 102mm / Modified Crank Case to take a 105mm Raptor Cylinder / 11:1 102mm JE Raptor piston / Stage 1 Raptor Hot Cam / Ported head / Colder Spark Plug / +2mm Throttle body / DNA stage 1 & 2 filters / Modified Air Box / Snorkel removed / Worry Brothers stage 2 filter cover / 6mm & 8mm Bolts Replaced with Titanium Bolts / Recovered seat in Black / O2 Eliminator /

My 09 XTX
59HP at the rear wheel / Stage 2 Raptor Hot Cam / DNA stage 3 Air Box / Carbon Can Exhausts / Modified Exhaust Link Pipes / PCIII With Custom Fuel Map / Wideband Commander O2 Data logger / LCD100 Dyno Jet display & fuel adjuster / 2500 OHM HT lead instead of a 10K OHM XT lead / Extra Coolant Cooler / Protaper Fat Bars / Tail Tidy With LED Tail Light / OKE Protection Knobs / LED indicators / AIS blocked / Modified rear sprocket rubbers / Rear Foot Pegs removed / 09 ECU With 02 Sensor Changed To A 06 ECU / Complete wiring harnes Changed from 09 to 04 / Home made LED resistor flasher / Hole drilled in the fuel tank filler neck to allow quicker filling / Modified Bar End Weights / Progressive front fork springs, 15W fork oil, forks lowered 25mm, used XTR rear links lowering the rear 20mm, rear spring one click stiffer / Changed front & rear guards from blue to black / 47T rear sprocket / Speedo Healer V4.0 / Kev throttle cam mod / Throttle grip mod / The new 2010 O2 sensor mod is out, works a treat, The new 2012 O2 Controller is out, PM me for details

Now ride a 2018 MT09SP ABS + TCS

My KTM 990 SMR Mod book. http://www.ktmsmt.com/viewtopic.php?f=13&t=4946

If the voltage shows 3,9 is it the sensor that is broken or could it be something else? I've cleaned the connectors and they look fine.
Btw, is the sensor expensive?


Skickat fr�n min iPhone med Tapatalk

What I dont get is why it wont reset? The engine light and the error code is still showing. I mean if you would have fallen with the bike so surely you must be able to reset it when you pick it up again?


Skickat fr�n min iPhone med Tapatalk

To reset if you have just fallen off it. Turn off the ignition completely and then turn back on and it should reset itself. (from experience)

__________________
XTz 660 tenere, adventure spec bash plate, main stand, skid marks tall screen, Oxford tail pack 36 litre. Kobra hand guards, Bigger cast footpegs, Zen overland luggage plate, USB power point, iridium spark plug, TKC80 f k60 R tyres, o2 and fuel Kev mods, DNA stage 2 filter. bark buster bar wieghts, Touratec side stand base and GPS mount. Led spot lights