|
|
Newbies Reception Lounge Newbie introduction forum, just say hi and show us your bike, tell us where you're from and how you've found us, and see how many will welcome you aboard!! |
|
Thread Tools | Display Modes |
|
#
1
|
|||
|
|||
New to the Blue in NZ
Hi, It's been a few years since I rode thumpers, a DRBig750 was my last one, Airhead twins are my normal mode of transport. But wanted to have something a bit lighter and like the look of the Tenere so when a crashed 2013 XTZ660 came up for auction, figured I had to give it a go. Nothing like having a project to think about.
I've got a complete 46mm YZ250 USD front end to graft onto the bent front end of the Tenere, so looking forward to that. The rest of it will need a bit of searching for replacement parts etc, so if anyone knows where to source parts close to New Zealand, I'm all ears. I'm still waiting for it to get delivered from Chch, so haven't been able to make a full assessment of what will be needed to get it road worthy yet.... But might as well start learning what I've potentially got and so far I'm looking forward to riding it. My "new" xtz660 tenere by DARREN MORRIS, on Flickr Last edited by DazzaXT; 23-01-16 at 16:28. |
#
2
|
||||
|
||||
and
to
|
#
3
|
|||
|
|||
Welcome on board mate.
Looks like an interesting project you've got there. You'll have to start a dedicated thread and keep us updated with the progress. |
#
4
|
|||
|
|||
Welcome to the forum Steve
|
#
5
|
|||
|
|||
Another XT on the trails...looks like yer got a bit
of work ahead of yer... got a complete XTR front end don't think any bits would be of much use on a XTZ.. If the YZ front end becomes a hassel to fit.. CR250 front end is a top bearing swap then it bolts straight in.. Pete
__________________
Harley Davidson.. The easyest way to turn gasoline into noise with out the side efect of horse power... |
#
6
|
|||
|
|||
Hello mate
|
#
7
|
|||
|
|||
Quote:
|
Thread Tools | |
Display Modes | |
|
|