any one no if wr or yz front foot rests fit a 2013 tenere,cheers

These will fit the Ten:

1996-2005 Yamaha YZ 80,
1987-1996 Yamaha YZ 125 / 250,
1987-1993 Yamaha YZ 500,
1990-1997 Yamaha WR 200,
1990-1997 Yamaha WR 250,
1987-1993 Yamaha WR 500

Read this thread regarding the above pegs available cheap on ebay. Some of the links might be out of date, but you'll get the idea.

__________________

thanks for that ,role on wales

http://www.ebay.co.uk/sch/m.html?_od...Text=&_sacat=0

I've been wondering what other foot pegs fit the Ten too, other than pivot pegs. Cheers


Sent from my iPhone using Tapatalk

I think my wide steel ones are from a TW200 or a TTR, can't figure out which.

All I had to do was bore out the fixing hole from 8mm to 10mm and they went straight on.

__________________
Bike: 2013 XT660Z, TKC70 tyres

Mods:
Barkbusters, Scottoiler, DIY Tail Mod, DNA Stage 3, Power Commander V & O2 Eliminator, Exan X-Black Stainless exhaust, Tool tube, Ohlins linear front fork springs, Nitron rear shock, JT front and Supersprox rear sprockets, D.I.D. VX 520 chain, Adventure Spec bashplate, DIY USB Outlet, DIY chain guide, Kev's Throttle mod

http://www.facebook.com/onemooseonemotorbike

I was about to do the "fabricate my own" deal but a trip to the shop might save me some time in the workshop.
Another reason to search this site for information/ideas as often as possible

__________________

Two wheels keeps you young. Regards. Russ

Had a look at a new off the shelf TTR footpeg, they''re the same size as the current Z but without the setup to bolt the rubber insert on top.
So still going down the fabrication line. Built two sets of enlarger wrap arounds from stainless sheet, fitted one set to the DR650 yesterday. Not as pretty as I'd hoped but that was the practice run . The Z job will be more refined

__________________

Two wheels keeps you young. Regards. Russ

It was easier to modify CRF foot pegs:



Much better..


I documented the process here:
http://www.wilddog.za.net/forum/inde...topic=174276.0

I have had the SW-Motech footrests for four years now. Much wider than stock and can be set in two positions, stock height or 15mm lower. Been very impressed - made things a lot more comfortable on long runs, as well as standing and removing the rubbers leaves a good serrated non-slip surface.

https://www.motorradgarage.com.au/fo...aha-xt660r-x-z

__________________