Home

Go Back   .: XT660.com - The #1 XT660 Resource :. > XT660 Tech Section > General Help Section
FAQ Calendar Search Today's Posts Mark Forums Read Main site

Google

General Help Section Members help each other here with tips and tricks about mods / maintenance and servicing based on their own experiences

Reply
 
Thread Tools Display Modes
  # 1  
Old 09-01-12, 14:38
timboo timboo is offline
Expert XT-Moto
 
Join Date: Nov 2011
Location: manchester
Posts: 84
timboo is on a distinguished road
When raining or washing bike cuts out

My bike runs fine in the dry or cold however once there is a heavy down poor of rain I'll be sat at some lights and the bike will just die and then takes about 2 minutes before i can try to restart her.

Also occurrs when washing the bike. I'm guessing its some form of electrical fault but not sure which part could be causing it, it only had a service last month and spark plug replaced.

Anyone else had this problem?

thanks
__________________
2004-2006 Yamaha R603 plate Akra carbon can Ohlins steering damper carbon air intakes/rear fender/hugger double bubble race screen YM600 cycle lock LED indicators tail tidy
2009 - 2009 Yamaha R657 plate with titanium Akra full exhaust system ASV short levers Carbon fuel tank/front fender/rear hugger Ohlins steering damper LED indicators, double bubble race screen
2011 - now Yamaha XT660X 56 plate mtc cans 2b contd...
  # 2  
Old 09-01-12, 15:13
pommie pommie is offline
XT-Moto SuperStar
 
Join Date: Dec 2008
Location: adelaide
Posts: 259
pommie is on a distinguished road
I would start looking at main ECU,remove seat and left side plastic cover there you will find the ecu remove the connectors plugs and check for no water damage also make sure the rubber seal is in the connectors plug
Alex

Sent from my X10i using Tapatalk
  # 3  
Old 09-01-12, 19:56
timboo timboo is offline
Expert XT-Moto
 
Join Date: Nov 2011
Location: manchester
Posts: 84
timboo is on a distinguished road
Quote:
Originally Posted by Keithblade View Post
I had this with my old XTR, the short bodge is to spray WD40 all over the terminals and leads. These are situated on the right hand side. The proper mad/repair is to take out all the leads and reseal them with tighter rubber caps and also a good dollop of an heat proof grease around the rubbers.

The rubbers could be split or just ill fitting and letting in moisture.

This should sort it out matey.
Thanks for the info strangely enough did occurr when washing right hand side. Wat sort/size rubbers required presume they don't need to be from yam being awkward sizes etc
__________________
2004-2006 Yamaha R603 plate Akra carbon can Ohlins steering damper carbon air intakes/rear fender/hugger double bubble race screen YM600 cycle lock LED indicators tail tidy
2009 - 2009 Yamaha R657 plate with titanium Akra full exhaust system ASV short levers Carbon fuel tank/front fender/rear hugger Ohlins steering damper LED indicators, double bubble race screen
2011 - now Yamaha XT660X 56 plate mtc cans 2b contd...
  # 4  
Old 09-01-12, 19:57
timboo timboo is offline
Expert XT-Moto
 
Join Date: Nov 2011
Location: manchester
Posts: 84
timboo is on a distinguished road
Quote:
Originally Posted by pommie View Post
I would start looking at main ECU,remove seat and left side plastic cover there you will find the ecu remove the connectors plugs and check for no water damage also make sure the rubber seal is in the connectors plug
Alex

Sent from my X10i using Tapatalk
Hi thanks for the info I will have a look just in case although I feel I more towards the front of the bike but u never know
__________________
2004-2006 Yamaha R603 plate Akra carbon can Ohlins steering damper carbon air intakes/rear fender/hugger double bubble race screen YM600 cycle lock LED indicators tail tidy
2009 - 2009 Yamaha R657 plate with titanium Akra full exhaust system ASV short levers Carbon fuel tank/front fender/rear hugger Ohlins steering damper LED indicators, double bubble race screen
2011 - now Yamaha XT660X 56 plate mtc cans 2b contd...
  # 5  
Old 09-01-12, 21:31
maxwell123455 maxwell123455 is offline
XT-Moto SuperStar
 
Join Date: Jul 2007
Location: Edinburgh, Scotland
Posts: 1,943
maxwell123455 is on a distinguished road
It does sound electrical.

I had something like this on my XTR, found out that the kill switch wire broke at the connector under the LHS of the tank. Once the mechanic found the problem and fixed it he suggested the same as Kev said for all the rest of the connectors as there is quiet a few on the LHS of the bike. Also the same for any of the connectors at the rear of the bike on both Right and Left hand side of the bike.
__________________
Plough on
  # 6  
Old 10-01-12, 14:35
timboo timboo is offline
Expert XT-Moto
 
Join Date: Nov 2011
Location: manchester
Posts: 84
timboo is on a distinguished road
Quote:
Originally Posted by maxwell123455 View Post
It does sound electrical.

I had something like this on my XTR, found out that the kill switch wire broke at the connector under the LHS of the tank. Once the mechanic found the problem and fixed it he suggested the same as Kev said for all the rest of the connectors as there is quiet a few on the LHS of the bike. Also the same for any of the connectors at the rear of the bike on both Right and Left hand side of the bike.

I'm convinced its electrical going to look at all of the bike diagrams an see whats wat. Think that will shed some light.

Failing that I'll buy a water pistol and squirt individual wires lol
__________________
2004-2006 Yamaha R603 plate Akra carbon can Ohlins steering damper carbon air intakes/rear fender/hugger double bubble race screen YM600 cycle lock LED indicators tail tidy
2009 - 2009 Yamaha R657 plate with titanium Akra full exhaust system ASV short levers Carbon fuel tank/front fender/rear hugger Ohlins steering damper LED indicators, double bubble race screen
2011 - now Yamaha XT660X 56 plate mtc cans 2b contd...
  # 7  
Old 11-01-12, 13:34
timboo timboo is offline
Expert XT-Moto
 
Join Date: Nov 2011
Location: manchester
Posts: 84
timboo is on a distinguished road
Quote:
Originally Posted by Keithblade View Post
Very intuitive matey!
The funny thing is initially I said it off the fly however thinking about it may actually prove useful
__________________
2004-2006 Yamaha R603 plate Akra carbon can Ohlins steering damper carbon air intakes/rear fender/hugger double bubble race screen YM600 cycle lock LED indicators tail tidy
2009 - 2009 Yamaha R657 plate with titanium Akra full exhaust system ASV short levers Carbon fuel tank/front fender/rear hugger Ohlins steering damper LED indicators, double bubble race screen
2011 - now Yamaha XT660X 56 plate mtc cans 2b contd...
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 18:31.
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.

  XT660         Archive   Main site


Footer
vBSkinworks Top