.: XT660.com - The #1 XT660 Resource :.

.: XT660.com - The #1 XT660 Resource :. ( https://www.xt660.com/index.php)
-   XT660Z Mods ( https://www.xt660.com/forumdisplay.php?f=165)
-   -   Hyperpro Suspension ( https://www.xt660.com/showthread.php?t=15698)

enduro374 21-12-10 10:38

Hyperpro Suspension
 
Does anyone have expereience (good or bad) with Hyperpro supension off road on the Ten'?

I got in contact with them and seems to me like they're not so sure about off road improvements.

With Ohlins @ �1k for the lot, the Hypropro is much more reasonable as long as it means the Ten' is no longer a soggy monster off road..

Thx

tripletom 21-12-10 12:39

Not with the Ten, but I fitted Hyperpro front springs to my Caponord and they made a huge difference.
I went to Nitron in Witney, Oxford for my rear shock. I can very much recommend them. It's just a shame they don't do fork springs :( I think I'll be looking at either RaceTech or Ohlins springs come next year.

Gas_Up_Lets_Go 21-12-10 14:44

I have HyperPro, front & rear.....


The front made a huge difference, much much more focused. The rear, well the first thing I noticed was the bike was sitting up lots more, my feet didn't touch the ground as well, so I concluded that the old spring had way too much sag.

On the whole, for the �200 (max price, it should cost more like �160 from memory ??) it's a worth while improvement.

However, the HyperPro comes with setup instructions and new oil, the oil is 5 rather than the Yamaha 15 so this could make a difference too I guess (I might hev the weights the wrong way round here, it's been one of 'them' days and my brain isn't functioning quite right!!)

enduro374 21-12-10 14:59

Thanks gents.

I was planning the whole rear shock and front springs, which is where I got the amount from.

I suspect the 15wt oil was the Hyperpro as it's thicker than the standard 5wt that Yamaha put in..

SingleMinded 22-12-10 10:11

Got them to, front and rear (complete shock), but didn't have a chance yet to put in the front springs.

As GULG sais: the rear is quite a bit higher. I'll first put in the front springs and then start fiddling with it. I did turned the damping to full open which is still a bit more firm then the standard. I didn't have a chance to test it on anything else then motorway and speed bumps.

The spec sheet says 'road' somewhere so I assume damping range is different then an 'off-road' spec? ... if such excists... 'cos I haven't been asked about the intended use when I ordered it...

GULG: how do the hyperpro's behave off-road?

HJ

Gas_Up_Lets_Go 22-12-10 10:17

Quote:

Originally Posted by SingleMinded (Post 145074)
GULG: how do the hyperpro's behave off-road?

Well within my capabilities !

I found them to wash out much less, the front does appear to keep in line better and a little more feedback.

Braking is funny. as the front doesn't dive withthe same 'lurch' but more controlled, you have to adjust yourself to get the best out of the brakes (I would gauge the braking by the distance of the front end dive, so I had to recalibrate my brain!)

It's much better on the 'c' road twisties, and can take on the moutian roads with loads of confidence too. Although with TCK's on the bike, the funny wear is a little more extreme than before the Hyperpro change.

zakidos 22-12-10 11:06

I've got the Hyperpro on the front (back is the �hlins) and I was impressed in Morocco when driving the piste. With the original springs I had a couple of times a full "snap-through", with the Hyperpros no topic at all. I'm glad I invested in these.

enduro374 22-12-10 11:16

As I expected - once you've improved the suspension only good things can happen!

zakidos 22-12-10 11:25

Quote:

Originally Posted by enduro374 (Post 145082)
As I expected - once you've improved the suspension only good things can happen!

And you never wanna go back to the stock suspensions anymore on any bike ;-)

Kev 22-12-10 11:41

I swear by these springs, they make a big difference to any bike.


All times are GMT +1. The time now is 01:21.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.