DISCLAIMER: YOU DO THIS AT YOUR OWN RISK AND MAY VOID THE MANUFACTURERS WARRANTY.

Throttle Sensor Adjustment:

To do this modification you need to put the bike in diag mode:

To access DIAG mode:

switch off Engine Run switch, switch OFF Key switch. Press both SELECT & RESET buttons and then switch ON Key switch. Keep SELECT & RESET buttons pressed for at least 8 seconds. Display then changes to "DIAG". Release SELECT & RESET buttons.
Select Diag mode by pressing again both SELECT & RESET buttons.
Select code below by pressing SELECT (up) or RESET (down).

On the digital display select 01 (throttle position) and make a note of the number on the screen. It should be between 16 - 18.

Now locate the throttle sensor, its on the right hand side of the bike behind the cylinder.

Slacken the two bolts indicated in the above photo. Using a T25 Torx.

If you rotate the sensor clockwise/ anti clockwise you will see the number of the digital display increase and decrease.

Set the value to between 15 & 18.

DISCLAIMER: YOU DO THIS AT YOUR OWN RISK AND MAY VOID THE MANUFACTURERS WARRANTY.

Attached Images

	DSCF2686.JPG (114.0 KB, 1539 views)
	DSCF2688.JPG (111.6 KB, 963 views)