Hi guys
Bikes not been start for a month or two thought I'd give it a run up today,
On turning the key pump runs and I get 22 where mileage should be, bike starts and runs fine but with a engine light, looked up code 22 and it's listed as air temp,
Is this likely to be my kev mod making it soo cold the ecu detects a fault it's about 2 degrees out today, or the wiring of mod, it was all soldered and shrink wrapped when fitted, and is it safe to ride like this ?

__________________
you win some, lose some, crash some
K+N filter, snorkel removed, homemade kev mod (with his blessing), co raised,
Pipeworx cans, r1 led back light, under tray removed, small indicators, handguards, cnc short levers,

I had the same a couple of years back. Turned out to be a beak in the circuit where the fuelling mod was connected.

If the error 22 is showing the ECU is receiving NO signal from the AIT sensor which means either the sensor has gone bad (unlikely) or there's a wiring fault. If the bike has been laid up, then it's likely to be a corroded or bad connection. Check the wiring and your solder joints. Also check the resistance of the Kev mod with a multimeter, making sure it changes smoothly as you twist the dial.

The bike is safe to run. The fail safe action is for the ECU is to fix the air temperature to 20C. The bikes may run a bit weak if the ambient temperatures are very low, but you'll be fine for a short while until you fix it.

__________________

Lovely, thanks,
Looked at the variable resistor and the lock nut on the outside of box is rusty, so I'll start there, keep meaning to get her mot'd and that's as far as I get lol,
Like you say,going to be a break in that circuit somewhere

__________________
you win some, lose some, crash some
K+N filter, snorkel removed, homemade kev mod (with his blessing), co raised,
Pipeworx cans, r1 led back light, under tray removed, small indicators, handguards, cnc short levers,