Looking for some help with this folks.

I recently purchased front and rear R&G bobbins from a forum member and I went out to fit them last night.

I have searched the forum to see if this has been discussed previously however I did not find a definitive answer so I'm looking for someone who has fitted these to assist me.

The bobbins came with the bar which goes through the front axle, 2x plastic spacers and of course the bobbins and Nylock nuts.

When fitting the plastic spacers, they appear slightly too thin and as a result, the bobbins sit at a slight angle.

Does anyone have any pics of there's fitted to an XTX (front and rear) and also a solution to the prob, other than fitting metal penny washers to fill the gap? I don't want it looking like a home made effort.

Thanks in advance.