|
|
Dealers, Purchasing, Insurance, & Warranty Warranty claims what is covered and what is not? Also Insurance Vs Mods discussions. |
|
Thread Tools | Display Modes |
#
1
|
||||
|
||||
side stand
today i waz out riding on my bike,i parked it on the grass went in the cafe when i came out the bike waz leaning at an alarming angle ,i thought it had sunk in the grass,when i looked at the sidestand it waz bent has this happened to anyone else?and is this covered under the waranty?
the bike is 14 months old
|
#
2
|
||||
|
||||
Yes a few people in the history of this forum have had their sidestand bent, most of them caused by themselves by sitting on the bike with it down. They are not very strong and they are not covered by warranty unless they just break in an unconventional place. But..... you can always try with your dealer. (they are not very expensive anyway)
|
#
3
|
||||
|
||||
thanks fran im not one of those who sits on the bike with the
sidestand down my dealer is pretty good ..so ive got a good chance ...
|
#
4
|
||||
|
||||
went to the yamaha dealer today and they had a look at the side stand,good news there giving me a new one well pleased
|
#
5
|
||||
|
||||
How do you say
jammy git in Stockholm?
|
#
6
|
||||
|
||||
not quiet sure how they would say that but they do say javla tur.... the luck of the devil
|
#
7
|
|||
|
|||
Bent Sidestand.
No idea how it happened, but mine is now bent, anyone know how much they cost??
|
#
8
|
||||
|
||||
if I remember rightly they are 45 quid before vat, an RAC towing flat bed truck once bent one of mine and they had to buy it back it came to about �64 all including fitting. (1.5 years ago)
|
#
9
|
|||
|
|||
Bloody ell, I think I'll bend it back ,weld on a splint an hope for the best!!! Thanx
|
#
10
|
|||
|
|||
My xtr came with a bend sidestand and i got told it was around �30 but i didnt wanna get a new one so took the bend one off, heated it rebent it, and then sprayed it up, its holding after 1 month of use but the paint around the heated area is started to peel only a wee bit.
It is possible but to get a splint in would mean the it would be very very small as if you have CCC cans the link pipe is very close to the back of the stand where you want to put a splint. If you know what i mean so clearance could be a issue.
__________________
Plough on |
Sponsored Links |
Thread Tools | |
Display Modes | |
|
|