|
#
1
|
|||
|
|||
Throttle Sensor Adjustment
DISCLAIMER: YOU DO THIS AT YOUR OWN RISK AND MAY VOID THE MANUFACTURERS WARRANTY.
Throttle Sensor Adjustment: To do this modification you need to put the bike in diag mode: To access DIAG mode: switch off Engine Run switch, switch OFF Key switch. Press both SELECT & RESET buttons and then switch ON Key switch. Keep SELECT & RESET buttons pressed for at least 8 seconds. Display then changes to "DIAG". Release SELECT & RESET buttons. Select Diag mode by pressing again both SELECT & RESET buttons. Select code below by pressing SELECT (up) or RESET (down). On the digital display select 01 (throttle position) and make a note of the number on the screen. It should be between 16 - 18. Now locate the throttle sensor, its on the right hand side of the bike behind the cylinder. Slacken the two bolts indicated in the above photo. Using a T25 Torx. If you rotate the sensor clockwise/ anti clockwise you will see the number of the digital display increase and decrease. Set the value to between 15 & 18. DISCLAIMER: YOU DO THIS AT YOUR OWN RISK AND MAY VOID THE MANUFACTURERS WARRANTY. Last edited by Kev; 11-08-07 at 09:15. |
Thread Tools | |
Display Modes | |
|
|