Home

Go Back   .: XT660.com - The #1 XT660 Resource :. > XT660Z T�n�r� > XT660Z T�n�r� Tech Section
FAQ Calendar Search Today's Posts Mark Forums Read Main site

Google

XT660Z T�n�r� Tech Section Tyres, Mods, Luggage & Long distance preparation

Reply
 
Thread Tools Display Modes
  # 1  
Old 25-10-15, 13:31
N.G. N.G. is offline
Newbie XT-Moto
 
Join Date: May 2013
Location: London
Posts: 8
N.G. is on a distinguished road
Unhappy Help! Nasty engine noise! Contains Video Link

Hi all,

I have a 2010 Tenere and I've just hit 30,000 miles, most of which has been in the past 2 years (mostly road use with some greenlaning). Recently it has developed a very nasty sounding engine noise.

For the past month, once a week, I have been doing quick motorway runs of about 200 miles sitting in top gear at high speed (obviously not what it's designed for). At the last oil change I took out about 1.8l so pretty low although my dealer said that shouldn't have caused too much damage??

https://youtu.be/Qjxm532PJZs

Also in the past few months the bike developed a backfire although this didn't affect the performance or sound of the bike. When cold and rolling off the revs the normal popopopop was replaced with silence from the exhaust before BANG. I mentioned it to the garage who said not to worry

I 'might' be running a little rich too. My fuel trip is kicking in about 20 miles sooner than before although this could be my riding.

So pretty stumped and not sure where to start. I've never worked on the tenere's engine before but I'm stupid enough to consider it. My girlfriend and I, although inexperienced, have done some open heart surgery on an old DR650 and learnt a lot so would be willing to dabble if time allows.

Hope you can help - thanks in advance,

Greg
  # 2  
Old 25-10-15, 16:25
Pleiades Pleiades is offline
XT-Moto SuperStar
 
Join Date: Aug 2010
Location: North Norfolk
Posts: 5,320
Pleiades is on a distinguished road
Sounds very much like a loose crank nut, which is a known problem and seems to effect a random selection of XTs over the years.

What you will need to do is remove the left hand engine cover (with water and oil pumps) and expose the primary drive gears. You can then access the 36mm nut on the end of the crankshaft, fit a new lock washer and re-torque it.

This thread is probably worth a read:

http://www.xt660.com/showthread.php?t=23951

It isn't an expensive job to do (just new gaskets etc.) unless the loose nut has caused other damage. In all the cases recorded on the forum, a re-tightening of the nut has rectified the issue with no further trouble.

Last edited by Pleiades; 25-10-15 at 22:10. Reason: typo
  # 3  
Old 25-10-15, 21:59
N.G. N.G. is offline
Newbie XT-Moto
 
Join Date: May 2013
Location: London
Posts: 8
N.G. is on a distinguished road
Brilliant. Definitely sounds worth a look.

Thanks for the quick response. I'll be back if it doesn't sound better!
  # 4  
Old 25-10-15, 22:09
Pleiades Pleiades is offline
XT-Moto SuperStar
 
Join Date: Aug 2010
Location: North Norfolk
Posts: 5,320
Pleiades is on a distinguished road
Sorry, should read 36mm nut (typo!)

Good luck - I hope it is the problem and you get it sorted.
  # 5  
Old 07-11-15, 18:06
N.G. N.G. is offline
Newbie XT-Moto
 
Join Date: May 2013
Location: London
Posts: 8
N.G. is on a distinguished road
All sorted. Exactly what you said. Once the cover was off the bolt was less than finger tight.

Due to lack of time and space I booked it in to my local Yam dealer. After a few phonecalls they establish that Yam are aware of the issue, but have made no manufacturing changes in this area since the birth of the new Tenere. He checked all the torque setting for each year and the part numbers remain the same.

Thanks very much for your help!
  # 6  
Old 23-11-15, 14:42
Halgeir Halgeir is offline
Newbie XT-Moto
 
Join Date: May 2014
Location: Leigh-on-Sea
Posts: 6
Halgeir is on a distinguished road
Hi there!
This thread just saved my bacon
Last week I suffered the same engine noise on my Tenere, and thanks to this thread I surmised that it too was due to this loose crank nut issue.

The descriptions, photos and video link truly helped and saved me vast amounts of faffing and head scratching and ultimately sorted the problem quickly and easily in just a few hours.
Thank you to you all.

Halgeir
Reply

Tags
engine, nasty, noise

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 10:49.
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.

  XT660         Archive   Main site


Footer
vBSkinworks Top