|
|
#
1
|
|||
|
|||
Scottoiler Positions
Hey have just ordered a Scotoiler V for my XTXand was wondering if anyone on here has them and the most important question were do you have them ?
Thanks |
#
2
|
|||
|
|||
Hiya I have one fit under the seat where the tools were I have put the tools into the rear light area they fit ok. After trial and error and a bit of spillage I find that if you support the scottoiler tank with some sponge held down with the black bands works a treat.
Hope that helps. |
#
3
|
|||
|
|||
This thread might be worth a read for those thinking of adding a Scottoiler to their R/X.
|
#
4
|
|||
|
|||
sitting on the bike rhs on the frame beside the rear brake resvoir, then run the feed under and across the engine, under the swing arm and done
__________________
Plough on |
#
5
|
|||
|
|||
|
#
6
|
|||
|
|||
Do you guys have the oil flinging onto the left exhaust pipe as well? I have it dripping from the front sprocket down to the pipe as wll and it burns onto it.
__________________
--------------------------------------------------------------------------------------------------------------------------------------- 2013 XT660X White | LeoVince X3 | Snorkel removed | Kev's fuel mod and O2 controller | Throttle grip mod |
#
7
|
|||
|
|||
I've recently installed one underneath the seat attached to frame on the right hand side about level with the exhaust mounts. Then fed the oil tube across the bike down the left hand side of the air box and next to the spring then used the holes in the swing arm to feed it to the back without being on show too much.
I've recently had to adjust mine as I was getting loads of over flow and it spraying off. It was dripping off every surface, must've knocked it once or twice when adjusting its position and set the flow to max. One of the reasons I like where I've put is that the dial is hidden underneath part of the frame so won't be knocked now its in place.
__________________
Yamaha XT660X '08' Blue | DNA Stage 1 | MTC 2 into 1 Carbon Oval | OTR Tail Tidy | Engine Painted Black | |
#
8
|
|||
|
|||
I've shoved mine under the seat and tilted it about 45 degrees using the oil drainer
Fed the cable down the frame and secured it on the inside of the swing arm. Managed to feed it inside the arm and out through a convenient hole underneath the arm. Used some copper wire to then guide it to the sprocket. Seems to be doing the trick. Will take some pics when I get chance Sent from my iPhone using Tapatalk |
#
9
|
|||
|
|||
That's cheap! I'll probably give it a go once my bottle runs out
__________________
--------------------------------------------------------------------------------------------------------------------------------------- 2013 XT660X White | LeoVince X3 | Snorkel removed | Kev's fuel mod and O2 controller | Throttle grip mod |
Thread Tools | |
Display Modes | |
|
|