Home

Go Back   .: XT660.com - The #1 XT660 Resource :. > XT660Z T�n�r� > XT660Z T�n�r� Tech Section
FAQ Calendar Search Today's Posts Mark Forums Read Main site

Google

XT660Z T�n�r� Tech Section Tyres, Mods, Luggage & Long distance preparation

Reply
 
Thread Tools Display Modes
  # 1  
Old 14-03-15, 12:42
greatescape greatescape is offline
XT-Moto SuperStar
 
Join Date: Aug 2014
Location: chichester
Posts: 2,258
greatescape is on a distinguished road
clocks being replaced

Having the clocks on the Tenere replaced under warranty next week, as there is moisture in them. Depending on the outside temperature they condense up quite badly. No quibble from the dealers about replacement .They had not seen this before on a Ten, and I don't use a pressure washer. I'll be back to zero mileage on the trip meter !! Steve
  # 2  
Old 14-03-15, 14:25
Pleiades Pleiades is offline
XT-Moto SuperStar
 
Join Date: Aug 2010
Location: North Norfolk
Posts: 5,320
Pleiades is on a distinguished road
I'm surprised your dealer hasn't come across it before? It's quite common place for the Z's clocks to mist up, particularly during the winter months. You only need to a search on here for "condensation" and you'll turn up quite a few posts.

Just don't expect a new set of clocks to cure the problem! I also had mine replaced under warranty when the bike was 20 months old (although unlike you, I had to cajole the dealer into doing it) and the new ones did/do exactly the same!

I don't believe it is actual water getting in to them, more that it is the atmospheric humidity in the instruments that migrates to the coldest part (the face) when the illumination warms up the air trapped inside. This is why its worse on a cold day and the condensation appears to get worse after starting the bike before it gets better when everything (including the clear faces has warmed up. However, this moisture stays trapped inside, it just stops condensing so you don't notice it, which is why the same cycle will repeat itself the next day. Generally, in the summer misting doesn't happen. Essentially, I don't think the rubber breather/vent hoses are either big enough or in the right place - it's a minor design floor.

One word of advice when you get them changed: Get the dealer to write in your service book when they were replaced and get it stamped with the official mark. Also take a date stamped photo of your clocks displaying the current mileage before you take it in to get done. This way you've covered you arse when it comes to selling the bike in the future.

Last edited by Pleiades; 14-03-15 at 15:17. Reason: correct autocorrect!
  # 3  
Old 14-03-15, 18:03
greatescape greatescape is offline
XT-Moto SuperStar
 
Join Date: Aug 2014
Location: chichester
Posts: 2,258
greatescape is on a distinguished road
Thanks Pleiades, I suspected as much about moisture in the clocks...luckily when I went to the dealers the misted up screen was at it's worst, so there was no way they could dispute it. Thanks as well for the point about stamping the change on the book...as the mileage is so low I wasn't going to bother, but as you say might save aggro later. Although I have no plans to ever sell it!! Steve
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 07:39.
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.

  XT660         Archive   Main site


Footer
vBSkinworks Top