Hi

ive ordered some Ranthal 613's to replace the standard (now bent) bars. just thought though...are my barkbusters going to fit?

im sure these 613's arent going to be higer enough so i will (somehow) need add a small riser too. so im guessing the clutch and throttle cables wont reach so will have to send them to venhill. (����)

so im guessing at Venhill they just swap the inners for longer ones? so there will be more inner cable showing at one end (as the outer will be the same length)

clear as mud?

Yes... the Barkbusters will fit fine.

The 613's are much higher than standard (25mm I think) bars (they are also a little wider), without fitting new throttle cables you will not get a riser in there.

In order to get the 613's fitted you will need to re-route your throttle cables. So it's tank off time!



the red line is the route your cables take today, you need to pull them back and re-route over the oil pipe, following the dotted blue line. This gives you enough cable to get the bars to full left hand lock with the 613's fitted.

__________________
>-------<

Never underestimate the power of stupid people in large groups.

that pics rings a bell...i was going to get 613's ages ago so maybe thats why ive seen it.

Well, they arrived today. hard to guage hight when there not on the bike but im convinced there still not going to be higher enough?

as anyone had the clutch and throttle cabled lengthened? if so, by how much? cant get my head round how the clutch cable can be lengthened (if it need to be) without also doing the outer (so the whole cable)?

The clutch cable should be long enough. Only the throttle cables are a little bit too short.

Venhill will do it for you, Ubberthumper had his done a while ago. Don't know how much or how long it took though....


If I were you, I'd try the bars first, it's not just the height, but the rise and sweep that changes. You *might* get away with a small riser, 10mm ??

__________________
>-------<

Never underestimate the power of stupid people in large groups.

yeah your right. i always try and plan any possible future work/problems as i had having my bike off the road.

Looked on the Venhill site but i think prices are for full custom cables and not alterations.

Just wondering...has anyone changed the handle bar mounts? (the bits that stand up off the yokes dont know there proper name)

Think it was about �70-80. It's a new cable inside and out, but you have to send them an original set which they take apart for the moulded plastic bits at the top, because they can't replicate them.

Before I added risers as well, I got away with the stock cables with 613s without even rerouting them.

How tall are you? I'm around 6'3". Just the 613s was great for most stuff. I've got them a bit higher now which is even better for standing, but it's right on the edge of what is comfortable sitting down.

Roll the bars as far forward in the clamps as you can before they hit the clocks on full lock. Gets them further from the pegs, which is what you are trying to do by raising them, and as a bonus, it stretches the cables a bit less.

__________________
I spent a lot of money on travel and racing motorcycles - the rest I just squandered.

XT660Z - Commuter, Adventurer...Racer?

www.dashmoto.net

Other bikes >> MT-03 / CG125BR-J / ER-6F
Departed >> ZXR400L3 / EC300 / DR-Z400E / DR800S / GPZ500S / GS400