|
|
Newbies Reception Lounge Newbie introduction forum, just say hi and show us your bike, tell us where you're from and how you've found us, and see how many will welcome you aboard!! |
|
Thread Tools | Display Modes |
|
#
1
|
|||
|
|||
Hi from Kent.
Morning All,
Great site, I have been doing my homework here on the 660Z. At 5'7" I am worried it might be a bit tall. I know there are options to lower the seat and suspension, if someone has done this can you comment on the ride and stability of the bike ?? Hoping to test ride one at my local dealer when the weather settles..... |
#
2
|
|||
|
|||
Welcome mate.
I am only 2" taller and I have lowered my ten and have no problems at all riding on the road. Off road I struggle some times in deep ruts as you would expect, but that is all.
__________________
Ride hard, Fall Softly. [SIGPIC][/SIGPIC] |
#
3
|
|||
|
|||
Welcome aboard mate.
I shouldn�t get too hung up on how tall the Tenere is. After all Gaston Rahier was only 5�3� and won the Paris-Dakar in 84/85 on a very tall bike! |
#
4
|
||||
|
||||
Welcome mate.
__________________
Click here to join the XT Supporter's scheme Mods that I have done to my XTX's My 04 XTX Stage 1 & 2 DNA filters / Kev fuel mod / snorkel mod / Drilled air box mod / Engine breather mod / Fork Spacer mod / 15w fork oil / [ My 07 XTX Raptor 700 cylinder 102mm / Modified Crank Case to take a 105mm Raptor Cylinder / 11:1 102mm JE Raptor piston / Stage 1 Raptor Hot Cam / Ported head / Colder Spark Plug / +2mm Throttle body / DNA stage 1 & 2 filters / Modified Air Box / Snorkel removed / Worry Brothers stage 2 filter cover / 6mm & 8mm Bolts Replaced with Titanium Bolts / Recovered seat in Black / O2 Eliminator / My 09 XTX 59HP at the rear wheel / Stage 2 Raptor Hot Cam / DNA stage 3 Air Box / Carbon Can Exhausts / Modified Exhaust Link Pipes / PCIII With Custom Fuel Map / Wideband Commander O2 Data logger / LCD100 Dyno Jet display & fuel adjuster / 2500 OHM HT lead instead of a 10K OHM XT lead / Extra Coolant Cooler / Protaper Fat Bars / Tail Tidy With LED Tail Light / OKE Protection Knobs / LED indicators / AIS blocked / Modified rear sprocket rubbers / Rear Foot Pegs removed / 09 ECU With 02 Sensor Changed To A 06 ECU / Complete wiring harnes Changed from 09 to 04 / Home made LED resistor flasher / Hole drilled in the fuel tank filler neck to allow quicker filling / Modified Bar End Weights / Progressive front fork springs, 15W fork oil, forks lowered 25mm, used XTR rear links lowering the rear 20mm, rear spring one click stiffer / Changed front & rear guards from blue to black / 47T rear sprocket / Speedo Healer V4.0 / Kev throttle cam mod / Throttle grip mod / The new 2010 O2 sensor mod is out, works a treat, The new 2012 O2 Controller is out, PM me for details Now ride a 2018 MT09SP ABS + TCS My KTM 990 SMR Mod book. http://www.ktmsmt.com/viewtopic.php?f=13&t=4946 |
#
5
|
|||
|
|||
Hi Mate
I too am only 5ft 9in and no worries its a light enough bike IMHO and i haven't lowered it , just slip of to one side a little and flat foot.....................or stop at a ROCK !!! Phil |
#
6
|
|||
|
|||
Rahier didn't have to stop at traffic lights. So his feet could stay on the footpegs.
|
#
7
|
||||
|
||||
and
to
There are ways around it, first and foremost, you can get a seat upholsterer to unstaple the vinyl cover and cut out about 2 inches of foam from the middle scoop where you seat and restaple it, then you can drop the fork yokes and adjust the rear shock: all 3 combined together will make the bike more accessible to you. |
#
8
|
|||
|
|||
Thanks for all the replies.
|
Thread Tools | |
Display Modes | |
|
|