Gents,

I just installed the OTR bashplate and found out it is way to close to the waterpump and engine side




What I eventually want is like here on the OTR site , the plate and bracket mounted , but with my bashplate there is 3-4 mm left , and at the other side only 1 mm space left





here the pictures from off the road to see the clear difference

















anyone with OTR bashplate who can check and comment here ?

I mailed OTR as well to see what they have to say about it ,

I double checked with friend of me and also he said there is no other way to attach everything together so it must be "as designed" but then the design is not really good here I think

thanks

Looks like a neat fit, but can't see this protecting your water pump though..

I reckon this is just manufacturing tolerances - it is a bent and welded plate, so maybe you can give it a gentle 'tweak'?

tolerance , ok , but not 2cm in difference I guess ..., it should just be right when you pay 130 euro for something

I put an OTR plate on my XTR. Same problem with waterump. I gave it a good hard tweak (bend) and it is now fine. They look strong but bend and dint quite easliy. Next time I will get one from b@b offroad. They are thicker and super strong.

This is the competition marketed by Adventure-spec. It is heavier but my requirement was to have protection to both the Waterpump and the Alternator cover.







Superb bit of kit, very sturdy and I've tested it!!!!!!!

__________________
If I'm not working, I'll be

I know , wanted to get this one first, but read good things about the otr one , which is cheap , so ordered it

look at the one from Jenny

huge difference with mine !