|
Before you arrive at the dyno.
1/ Tyres pumped to correct pressures, used a road tyre not a trail or knobbly tyre.
2/ Adjust chain to correct tension & must be lubed, chain must be in good condition.
3/ Full tank of fresh fuel, as some runs can take a few hours to complete.
4/ The AIS must be blocked off otherwise a incorrect A/F ratio will be seen by the dyno tuner & the fuel map will be wrong.
Make sure they use Tune link software to build the fuel map, this software is the best & quickest way to make a fuel map. I would not recommend them to hand build your fuel map when you are paying top $ for the tune, they must use Tune Link.
99% of fuel maps are made from 2000rpm upwards, so set your CO 1 back to standard before going for the dyno tune & they will be able to adjust the dash to get the correct A/F ratio at idle.
__________________
Click here to join the XT Supporter's scheme
Mods that I have done to my XTX's
My 04 XTX
Stage 1 & 2 DNA filters / Kev fuel mod / snorkel mod / Drilled air box mod / Engine breather mod / Fork Spacer mod / 15w fork oil /
[
My 07 XTX
Raptor 700 cylinder 102mm
/
Modified Crank Case to take a 105mm Raptor Cylinder
/
11:1 102mm JE Raptor piston
/
Stage 1 Raptor Hot Cam
/
Ported head
/
Colder Spark Plug
/
+2mm Throttle body
/
DNA stage 1 & 2 filters
/
Modified Air Box
/
Snorkel removed
/
Worry Brothers stage 2 filter cover / 6mm & 8mm Bolts Replaced with Titanium Bolts
/
Recovered seat in Black
/
O2 Eliminator
/
My 09 XTX
59HP
at the rear wheel
/
Stage 2 Raptor Hot Cam
/
DNA stage 3 Air Box
/
Carbon Can Exhausts
/
Modified Exhaust Link Pipes
/
PCIII With Custom Fuel Map
/
Wideband Commander O2 Data logger
/
LCD100 Dyno Jet display & fuel adjuster
/
2500 OHM HT lead instead of a 10K OHM XT lead
/
Extra Coolant Cooler
/
Protaper Fat Bars
/
Tail Tidy With LED Tail Light
/
OKE Protection Knobs
/
LED indicators
/
AIS blocked
/
Modified rear sprocket rubbers
/
Rear Foot Pegs removed
/
09 ECU With 02 Sensor Changed To A 06 ECU
/
Complete wiring harnes Changed from 09 to 04
/
Home made LED resistor flasher
/
Hole drilled in the fuel tank filler neck to allow quicker filling
/
Modified Bar End Weights
/
Progressive front fork springs, 15W fork oil, forks lowered 25mm, used XTR rear links lowering the rear 20mm, rear spring one click stiffer
/
Changed front & rear guards from blue to black
/
47T rear sprocket
/
Speedo Healer V4.0
/
Kev throttle cam mod
/
Throttle grip mod
/
The new 2010 O2 sensor mod is out, works a treat, The new 2012 O2 Controller is out, PM me for details
Now ride a 2018 MT09SP ABS + TCS
My KTM 990 SMR Mod book. http://www.ktmsmt.com/viewtopic.php?f=13&t=4946
|