View Single Post
  # 17  
Old 04-03-09, 22:50
Kev's Avatar
Kev Kev is offline
Administrator
 
Join Date: May 2006
Location: Brisbane, Australia
Posts: 6,063
Kev is on a distinguished road
Quote:
Originally Posted by peach View Post
Got home from work this evening and tried the XT. Key in, ignition on, no errors but no EFI priming either (you know the noise you get as the fuel pump pressurises).

Ignition on and off a few times and eventually EFI primes. Press starter and nothing.

Ignition off and on, no EFI, off and on, got EFI, press starter, got a tick!!! We have progress!!!

Repeated this several times and we have a starter.

Long story short, after several minutes I manged to get the bike to start whereupon it ran for half a minute then stopped. Repeated the same steps (fewer times) and got it started again. This time it ran for five minutes before I switched it off. We have takeoff!!!

I have managed to get tomorrow morning off work and will take the tank off and check the connectors underneath. Will also run the diagnostics and check the sensors.

For all the advice received so far, much appreciated and

Tonight I have reached the stage until tomorrow...
Sounds like a low voltage battery or loose battery terminals or poor earth points.
__________________
Click here to join the XT Supporter's scheme

Mods that I have done to my XTX's

My 04 XTX
Stage 1 & 2 DNA filters / Kev fuel mod / snorkel mod / Drilled air box mod / Engine breather mod / Fork Spacer mod / 15w fork oil /
[
My 07 XTX
Raptor 700 cylinder 102mm / Modified Crank Case to take a 105mm Raptor Cylinder / 11:1 102mm JE Raptor piston / Stage 1 Raptor Hot Cam / Ported head / Colder Spark Plug / +2mm Throttle body / DNA stage 1 & 2 filters / Modified Air Box / Snorkel removed / Worry Brothers stage 2 filter cover / 6mm & 8mm Bolts Replaced with Titanium Bolts / Recovered seat in Black / O2 Eliminator /

My 09 XTX
59HP at the rear wheel / Stage 2 Raptor Hot Cam / DNA stage 3 Air Box / Carbon Can Exhausts / Modified Exhaust Link Pipes / PCIII With Custom Fuel Map / Wideband Commander O2 Data logger / LCD100 Dyno Jet display & fuel adjuster / 2500 OHM HT lead instead of a 10K OHM XT lead / Extra Coolant Cooler / Protaper Fat Bars / Tail Tidy With LED Tail Light / OKE Protection Knobs / LED indicators / AIS blocked / Modified rear sprocket rubbers / Rear Foot Pegs removed / 09 ECU With 02 Sensor Changed To A 06 ECU / Complete wiring harnes Changed from 09 to 04 / Home made LED resistor flasher / Hole drilled in the fuel tank filler neck to allow quicker filling / Modified Bar End Weights / Progressive front fork springs, 15W fork oil, forks lowered 25mm, used XTR rear links lowering the rear 20mm, rear spring one click stiffer / Changed front & rear guards from blue to black / 47T rear sprocket / Speedo Healer V4.0 / Kev throttle cam mod / Throttle grip mod / The new 2010 O2 sensor mod is out, works a treat, The new 2012 O2 Controller is out, PM me for details

Now ride a 2018 MT09SP ABS + TCS

My KTM 990 SMR Mod book. http://www.ktmsmt.com/viewtopic.php?f=13&t=4946