Quote:
Originally Posted by
Pleiades
Sorry, I though you meant start it in first, rather than start it and then change into first!
|
No problem my be my bad english aswell
Quote:
Originally Posted by
Pleiades
Next obvious question: Is the clutch cable moving freely through the outer?
|
Yes it moves freely.
Quote:
Originally Posted by
Pleiades
No it isn't. There should be no movement or gaps between the plates. If there is the most likely cause is the pressure plate isn't engaged properly with the basket and as a result the pull rod won't do its job either. Did you remember the thrust washer before refitting anything else? Did you remember the anti-judder seat and spring, which must be fitted the right way round (marked 'outside'). Are the plate tabs correctly located in the correct slots marked with triangles on the basket? The first (innermost) friction plate fits into the deeper right-hand slot (looking when the slots are at the top) and the final friction plate goes in the shallow left-hand slot.
|
Well i fitted all the plates in the correct order as is shown in my Haynes repairmanual for the bike. I do have the final friction plate on the left sid between the two triangels and the rest on the left side. the spring plate is mounted with the text outwards. im thinking about the thrust washer if i fitted that correctly or not. I seem too remember that i fitted it between the outer basket and the inner basket but i recall that i thought it looked a bit odd that the washer could move around the axel freely, i might have fitted it wrong after all.
I will be checking it later this weak when i get time to have a look at it.