Just had the rear wheel out of my XT660z for deep cleaning around the rear and now its time to put the rear wheel back on, but, do I torque wrench the rear 22 mm U-flange nut to 105nm or tighten to ��.as hard as you can without using the torque wrench��.

This isn�t the first time, in not using the torque, I�ve been told this this week as, apparently, using the specified wrench will overtighten the nut and thus be a real problem in undoing it at a later date, too, using the torque, at 105nm, will over tighten the nut as to ruin the bearings...


So, do you guys� torque to the correct setting or does doing it by hand give you more piece of mind or does both ways work okay�???

Thanks�