Fitted the pro taper bars today and off the road clamps/20mm bar riser kit. had to fit 20mm bar riser ready to install the steering damper thats on its way from oz. (ralle moto)worst part of the job was drilling out the heads on the sheer bolts on the ignition barrel ready for the steering damper to bolt in to. its getting there!. next on the list is rear hyper pro spring and front springs, bark busters on thier way, then finally going next week to have pcv and dyno set up. http://i1154.photobucket.com/albums/...e530/001-1.jpg