Kev, I have a couple of questions that I think you can answer....please

1) In relation to the discussion above, would changing my CO1 setting via the dash not globally increase the richness of the mixture?

2) Is one of these the same as your fuel mod? http://cgi.ebay.co.uk/NITRO-X-FUEL-C...4.c0.m14.l1262 i.e it alters the readings from the temp sensor?

3) If I was to find a PC111 cheap enough, could that be used while the o2 sensor is still in place in the closed loop system? Or would I have to buy an o2 eliminator too?

and finally..

4) On your fuel mod, you list a 0-1k resistor, do you use the full range of that pot? I only ask as I have a few 500 ohm pots here at work. But no 1k's at the moment.

Thanks

Lee