removing baffles
 

have some titanium ccc i know it might be simple and straight forward but can sombody tell me the way to remove the baffles i know it the screw underneath but i don't want to start pulling on the wrong thing!!! you know what it's like lol!
thanks.:family:

There is only one rivet holding each baffle in place, the rivet will need to be drilled out first. Once the rivets are out, you need some long neck pliers to pull them out. Simple as that.

If this helps - the rivet is only a couple of centimetres from the end.

http://i254.photobucket.com/albums/h...o/P1000432.jpg

so whats the two self tappers (screws) at each end of the cans underneath that look as if they go through the baffles i thought you would take these out and they come out easy????

When the cans are first made they have a pop rivet in but most people drill them out and put a screw of some sort in as the pop rivet can come loose and fall out after time.

The picture monty shows the 2 baffles out, the left one has a small hole on the under side of the baffle where the screw should go in. Take the screw out (slowly so's not to core the threads) and then as capt says get some pointy nose pilers, take a good grip of the small in pipe that comes out of the baffle and sort of wiggle and pull it out. It takes some tugging it get it out but will come out dont worry.

but be warned with not baffles in it will be

LOUD AS FUSH:066:

thanks guys!!!

well are they out yet? or WHAT??

:director2::director2:

wow
 

FANTASTIC :HeyHey_GOO2MN:

Are they much louder with the baffles out?

very loud with lots of popping on closing down the throttle, think i might put them back soon don't want to much attention from the POLICE, and they sound nice with baffles in also. good fun though seeing the face's of car driver's as you rev it in standing traffic lol.