.: XT660.com - The #1 XT660 Resource :.
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

.: XT660.com - The #1 XT660 Resource :. ( https://www.xt660.com/index.php)
-   XT660X & XT660R General Discussions ( https://www.xt660.com/forumdisplay.php?f=121)
-   -   RPM display in the dash ( https://www.xt660.com/showthread.php?t=11677)

450X 24-09-09 19:27
I just chekce dthe manual it does explain this in the manual, seem this feature is supposed to be tempary as it is used to set idling and the CO2 therefore it cancel out every time you turn your bike off/

grumpy 24-09-09 21:29
I tried it, 09 x, it works but only on the diagnostic screen not the normal screen, it cancels on switching off, then reverts back to normal screen.

Kev 24-09-09 23:28
All the above statements are correct.

bonjo 28-09-09 18:42
Finally there!!
 
Quote:
Originally Posted by Kev (Post 106375)
It should work on a 09 XT try this.

Switch off Engine Run switch, switch OFF Key switch.

1/ Press both SELECT & RESET buttons and then switch ON Key switch, keep SELECT & RESET buttons pressed for at least 8 seconds. Display then changes to "DIAG". Release SELECT & RESET buttons.

2/ Press the SELECT button once until CO displays, press SELECT & RESET buttons again, CO1 should display.

3/ Once selected CO1, switch on the kill switch & crank the motor. Once started the rev counter should be in the right side of the LCD screen.

Hope that works for you.
Ok here is what was missing:

in step 2, after the CO display, you need to press & hold SELECT & RESET for 2 seconds to get to CO1 I was doing it only momentarily.
Once done the display only shows RPM. I was :089:as I was hoping to get a feel for road speed against engine rpm.
Also noted that the odometer & trip meters stop registering while you ride the bike in test mode


All times are GMT +1. The time now is 04:19.
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.