![]() |
Bike won't idle
Out for a run today on my XT660R 2006. After about half an hour, she has a couple of little coughs and then cuts out.
The bike has a PCIII , DNA stage 1 and 2 and MTC cans. She has been dyno'd and the A/F is set as good as it going to be. She starts again and idles for about 20 seconds and then cuts out again. I have had the tank off and emptied the fuel and will put fresh in tomorrow. I can hear the fuel pump working ok. Is there anything else I should be looking for? Cheers Mike |
Quote:
That's about it. |
Changed the fuel, no joy runs for 20 to 30 seconds and cuts out. Adjusted the screw as Capt described, still the same.
Any other ideas? Cheers Mike |
Tried it with the petrol cap off ???
|
Tried it with the cap off, still the same.
Had enough for today. Will look again tomorrow |
Ok, this might be a long shot, and I will point Kev to this thread to shed some possible light, but I have a suspicion that if you have carried out all those steps and the bike it's still not idleing then the culprit may well be the TPS (Throttle Position Sensor) which it might either need adjusting or, if your bike its a 2005-2006 it may well be that it might have skipped the TPS recall that Yamaha issued at the time, replacing them all free of charge to all owners.
Now Kev will ask you to remove the TPS and read him the serial number once hew knows that he will tell you if your TPS falls under the recall range or not and he might have to give you further suggestions. good luck and don't worry one way or another we'll get to the bottom of this. |
A quick test of the TPS, can you go into the PCIII software & read off the throttle position while turning the throttle, does it go from Zero to 100% uniformly?
Have you blocked off your AIS pipe? |
Also please be reminded that Kev can only give you a few tips unless you join the XT Supporter scheme he can't go into full details
http://www.xt660.com/showthread.php?t=1475 |
Kev
I will have a look at the throttle response tonight and come back to you. The AIS is blocked. Capt Will get myself signed up tonight Cheers Mike |
The reason why I asked about blocking the AIS is I had a forum member block the wrong pipe before. Are you sure you blocked the AIS pipe & not the idle control valve pipe, they sit side by side?
|
All times are GMT +1. The time now is 23:57. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.