As regards setting throttle position when installing a PC bellow you can find the official instructions from powercomander.com:

We have seen as high as an 8% variation in the throttle position from bike to bike. If yours is not reading �zero� at idle with the motor at normal temperature, then use the following procedure to correct it. In the Power Commander Control Center Software, go to menu �Power Commander Tools� and look for the tool to calibrate the throttle. The bike should always be running when setting the throttle position, as the voltage the sensor sends out can vary between when the bike is at �key on� and �motor running�. The bike also needs to be at fully warmed up to its normal operating temperature. All you need to do is press "reset" while the bike running at idle, then quickly turn the throttle wide open till you hit the mechanical stop, then let go. Next press "Ok". You don't have to rev the bike out, the throttle just needs to go all the way to wide open and then back to idle.

Source: http://www.powercommander.com/powerc...nder_faqs.aspx

Thanks for the guide but i have a problem that i dont have the connectors for the tps instead i only have a red lets say "clamp" that is sharp and i guess it connects to a wire on the tps.
http://www.powercommander.com/downlo...ger412-411.pdf
its the Fig D. picture. thats the only part im missing to instal my PC3. i hope you can tell me where do i need to put that cable

This is where I mounted the PCIII unit when I installed it on my Tenere. I just used a trip of aluminium cut to fit and bolted in place at either end. I wrapped it in duct tape and fixed the PCIII unit in place using velcro.

https://www.aberdeenbikers.eu/galler...00717-1509.jpg